Installing your Replacement Screen Protector
Installing your replacement screen protector so it's ready to be fitted to your iPhone has never been simpler. This guide is for all our SKNS Screen Protectors from the iPhone 13 series up to the iPhone 15 series. Follow the instructions below, and your new screen protector will be ready in no time!Β
Step 1: Prepare the Guide Tray: Position the guide tray so itsΒ frontΒ side is on the bottom, the inner side where your iPhone would go during installation should be facing up.
Step 2: Position the Screen Protector: Place your new screen protector inside the guide tray. Ensure the tab labeled "anti dust" is facing upwards.
Step 3: Secure the Protector: You'll notice two smallΒ notches at the top of the tray and two holes on the screen protector. Align these holes with the tabs. Start by hooking the protector onto the tabs from the top. Then, gently press downwards until the lower part of the tabΒ locks into place, this will keep the screen protector aligned.
Step 4: Final Adjustment: Locate a thin slot at the bottom of the guide tray. Slide the pointed end of the anti-dust tab into this slot. This stepΒ locksΒ the screen protector in place so it won't move around when you're about to apply it to your device.
And there you go, your screen protector is properly set in the guide tray and ready for application. If you need a refresher on how to install your screen protector feel free to go over the installation guide here!
